DESIGN AND CONSTRUCTION OF A REFLUX COLUMN DISTILLATION UNIT FOR BIO-ETHANOL PRODUCTION FROM SUGARCANE SUBSTRATE

Authors

  • J. O. Olaoye Department of Agricultural and Biosystems Engineering, University of Ilorin.

Keywords:

Biomass, Biofuel, Ethanol, Distillation, Energy Crop, Alternative Energy

Abstract

A bio-ethanol distilling tank was designed and constructed to distil ethanol from sugarcane substrate. The machine has a capacity to process 200 litres of substrate at full load of the boiler. The distiller has mlntemalReflux Still Condenser (IRSC) that controls the internal re-distillation process and the separation of the final output. The column diameter was 40 mm. An anaerobic fermentation of substrate was adopted before distillation could be carried out. The fermented substrate was adjusted to an optimum pH level value of 4-5 by addition of 0.1 M HjSQ, and the optimum temperature was within the temperature range of 29-38°C. A charcoal pot was used as heat source. The results of the machine evaluation showed that optimum yield occurred at 0.0325 ratio of substrate to ethanol yield. An average distilled product of 2.1 litres was obtained at highest ratio of substrate to ethanol yield of 0.033 when the distillation time was 45 minutes. The total distilled products after 1XA hours of distillation was estimated at 4.25 litres. It was observed that the fermentation and distillation processes were done in situ, and could definitely affect clear separation of the fermentable portion of the fermented sugar solution.

Downloads

Published

2011-06-01

Issue

Vol. 8 No. 1 (2011)

Section

Articles

License

In accordance with the Copyright Act of 1976, which became effective January 1, 1978, the following statement signed by each author must accompany the manuscript submitted: "I, the undersigned author, transfer all copyright ownership of the manuscript referenced above to the Nigerian Journal of Technological Development, in the event the work is published. I warrant that the article is original, does not infringe upon any copyright or other proprietary right of any third party, is not under consideration by another journal, and has not been published previously. I have reviewed and approve the submitted version of the manuscript and agree to its publication in the Nigerian Journal of Technological Development." A copyright transfer form should be downloaded from the NJTD Website ( http://njtd.com.ng/index.php/njtd). Author(s) will be consulted, whenever possible, regarding republication of material. All authors must have access to the data presented and the authors and sponsor (if applicable) must agree to share original data with the editor if requested.