Soil Compaction Caused by Traffic Frequency of Rubber-Tracked Excavator
Keywords:
Induced compaction, Excavator, Penetration resistance, Rut depthAbstract
The project site described in this study was assumed to have been subjected to induced compaction of the excavator that was used to clear the land. It was therefore necessary to estimate the compaction so induced. The experimental soil was a sandy clay soil. The main objective of this study was to evaluate the soil compaction induced by traffic of rubber- tracked, medium size Excavator, 31.9 KW power and 36.4 KN weight in a sandy clay soil. The study was conducted at the Experimental site of the STEP B project of the Federal University of Technology. Akure (FUTA), Nigeria. The experimental soil was subjected to 1. 3, 5, 7, 9 and 11 passes of the Excavator. Variables measured include penetration resistance (PR), bulk density (BD), and rut depth (RD). The variables were monitored at the centre lines of the left (L) and right(R) tracks of the Excavator. Results showed that means of the L and R values were not significantly different at the 5% level of significance. Mean values of the PR in the depth range of 0 to 30 cm were 1102.85, 1363.65, 1163.5,1269.60, 1315.05 and 1428.8 kPa for 1,3,5,7,9 and 11 passes respectively. PR increased with depth to a limit and then reduced in value in the range of depth considered. The maximum PR value occurred between 15 and 20 cm depth. The average PR value before the excavator passes (control) was 420 kPa which was significantly different from those after the passes. The range of rut depth corresponding to 11 passes was 4.6 and 14.8 cm. The moisture content during the experimentation ranged from 11.5 - 15.5% (db) in the depth range. ,
Downloads
Published
Issue
Section
License
In accordance with the Copyright Act of 1976, which became effective January 1, 1978, the following statement signed by each author must accompany the manuscript submitted: "I, the undersigned author, transfer all copyright ownership of the manuscript referenced above to the Nigerian Journal of Technological Development, in the event the work is published. I warrant that the article is original, does not infringe upon any copyright or other proprietary right of any third party, is not under consideration by another journal, and has not been published previously. I have reviewed and approve the submitted version of the manuscript and agree to its publication in the Nigerian Journal of Technological Development." A copyright transfer form should be downloaded from the NJTD Website ( http://njtd.com.ng/index.php/njtd). Author(s) will be consulted, whenever possible, regarding republication of material. All authors must have access to the data presented and the authors and sponsor (if applicable) must agree to share original data with the editor if requested.