Impact of Pavement Roughness on Traffic Safety under Heterogeneous Traffic Conditions
Keywords:
pavement conditions, traffic safety, International Roughness Index, crash rate, carriagewayAbstract
Highway safety is a major priority for the public and for transportation agencies. Pavement roughness directly affect ride quality, and indirectly contribute to driver distraction, vehicle operation, and road traffic accidents. This study focuses on analysing the influence of pavement roughness on traffic safety using data on dual and single carriageway operated under heterogeneous traffic conditions in South-west, Nigeria. Two main types of data were collected for the years between 2012 and 2015: traffic crash data was obtained from the Federal Road Safety Commission (FRSC) and International Roughness Index (IRI) data from the Pavement Evaluation Unit of the Federal Ministry of Works, Kaduna. Crash road segments represented 63 percent of the total length of roads. IRI values for crash and non-crash segments were close to each other, suggesting that roughness is not the only factors affecting number of traffic crashes but a combination with other factors such as human error, geometric characteristics and vehicle conditions. Crash severity was categorized into Fatal, serious and minor injury crashes. In all cases, the total crash rate increases with increase in IRI value up to a critical IRI value of 4.4 and 6.15 for Sagamu-Ore road and Ilesha-Akure-Owo road respectively, wherein the crash rate dropped. This is a key conclusion that provides empirically derived thresholds for safety concerns. If transportation agencies keep their road network below these critical pavement conditions, the crash rate would largely decrease. It is concluded that ride quality does not directly affect traffic crash rate.
References
Blackburn, R.K. et al., “Effectiveness of alternative skid reduction measures. Report FHWA- RD-79-21, Federal Highway Administration, Washington, D.C., 1978.
Cairney, Peter, and Paul Bennet. (2008). "Relationship between Surface Characteristics on Selected Rural Roads in Victoria Rural Roads." ARRB Conference. ARRB Group.
Cenek, P. D, and B R Davies. (2004). Crash Risk Relationships for Improved Safety Management of Roads. Towards Sustainable Land Transport Conference.
Chan, C. Y, B Huang, X Yan, and S Richards. (2010). "Investigating Effects of Asphalt Pavement Conditions on Traffic Accidents in Tennessee Based on the Pavement Management System (PMS)." Journal of Advanced Transportation 44(3) 150-161.
Chandra, Satish, Chalumuri Ravi Sekhar, Anish Kumar Bharti, and B. Kangadurai. "Relationship between Pavement Roughness and Distress Parameters for Indian Highways." Journal of Transportation Engineering 139, no. 5 (2012): 467-475.
Garber, N.J. and Hoel, L.A. (2015). “Traffic and Highway Engineering,” 5th Edition,
Cengage Learning, Stamford, CT.
Hall, J. W. et al. (2009). "Guide for pavement friction," NCHRP Project: 1-43, Washington, DC.
IHS, A. The Influence of Road Surface Condition on Traffic Safety and Ride Comfort. 6th International Conference on Managing Pavements: The Lessons, The Challenges, The Way Ahead, 2004.
King, Bernie-Anne, “The Effect of Road Roughness on Traffic Speed and Road Safety,” Ph.D. dissertation, University of Southern Queensland, Australia, Nov. 2014.
Kuttesch, Jeffrey S. (2004). "Quantifying the relationship between skid resistance and wet weather accidents for Virginia data," PhD dissertaion, Virginia Polytechnic Institute and State University, Vicksburg, VA.
Li, Yingfeng. (2014). "Safety Impact of Pavement Conditions." Transportation Research Board 93rd Annual Meeting, 14-5373.
Li, Yingfeng, Liu Chunxiao, and Ding Liang. (2013). "Impact of Pavement Conditions on Crash Severity." Accident Analysis & Prevention, 399-406.
Masaeid, H. R. 1997. Impact of Pavement Condition on Rural Road Accidents. Can J Civ Eng. 24: 523–532.
Noyce, David A. et al. (2005). "Incorporating Road Safety into Pavement Management: Maximizing Asphalt Pavement Surface Friction for Road Safety Improvements." Draft Literature Review and State Surveys, Midwest Regional University Transportation Center (UMTRI), Madison, WI.
Owolabi, A.O; Abiola, O.S. (2011). Development of priority index assessment model for road pavements in Nigeria. In Proceedings of the 8th International Conference on Managing Pavement Assets (ICMPA), Chile.
Owolabi, A. O., Sadiq, O. M., and Abiola, O. S. (2012). Development of Performance Models for a Typical Flexible Road Pavement in Nigeria, International Journal for Traffic and Transport Engineering, 2(3): 178 – 184.
Quinn, B.E., and Hilderbrand, S.E., (1973): Effect of Road Roughness on Vehicle Steering, Highway Research Record 47, pp.62-75.
Sayer W.S (1986). Guidelines for conducting and calibrating road roughness measurements. World Bmk Technical Paper Number 46. The World Bank, Washington D.C
Tehrani, S. Sharif, and L Cowe Falls. (2012). "A Comparison of IRI and Collision Rates in the Province of Alberta." Canadian Society for Civil Engineering. Canadian Society for Civil Engineering. 1024, 1.
TRB (2009) “Influence of Roadway Surface Discontinuities on Safety: State of the Art, Transportation Research Circular No. E-C134, Transportation Research Board, National Research Council, Washington D.C.
WSDOT. 2005. Washington State Department of Transportation Pavement Guide. Available from Internet: <http://training.ce.washington.edu/WSDOT/>.
Additional Files
Published
Issue
Section
License
In accordance with the Copyright Act of 1976, which became effective January 1, 1978, the following statement signed by each author must accompany the manuscript submitted: "I, the undersigned author, transfer all copyright ownership of the manuscript referenced above to the Nigerian Journal of Technological Development, in the event the work is published. I warrant that the article is original, does not infringe upon any copyright or other proprietary right of any third party, is not under consideration by another journal, and has not been published previously. I have reviewed and approve the submitted version of the manuscript and agree to its publication in the Nigerian Journal of Technological Development." A copyright transfer form should be downloaded from the NJTD Website ( http://njtd.com.ng/index.php/njtd). Author(s) will be consulted, whenever possible, regarding republication of material. All authors must have access to the data presented and the authors and sponsor (if applicable) must agree to share original data with the editor if requested.