Characterization and Analysis of Propagation Time Delay Range within NigComSat-1R Footprints

Authors

  • A. T. Ajiboye University of Ilorin, Ilorin
  • A. O. Yusuf Department of Computer Engineering, University of Ilorin, Ilorin, Nigeria
  • R. A. Ajayi Department of Computer Engineering, University of Ilorin, Ilorin, Nigeria

Keywords:

Footprint, networked control system, Nigcomsat-1R, propagation time delay, quality of performance

Abstract

NigComSat-1R could be part of Networked Control Systems (NCSs) to link plants, controllers, sensors and actuators which may be distributed within the satellite footprints. Associated with NCSs is location-dependent time delay which can drastically reduce system Quality of Performance (QoP), or in the worst case lead to system instability. To ameliorate these effects, the network delay should be taken into consideration at design stage. In order to achieve this, the ranges of propagation time delay incurred within a particular footprint or between two footprints of NigComSat-1R are modelled, simulated, characterized and analyzed. It was observed that the minimum and maximum possible time delays between the boundary of NigComSat-1R footprints and the satellite are 0.1193 sec and 0.141 sec respectively. Also, the minimum possible propagation time delay between any two footprints is that between C-band ECOWAS 1 beam and itself with value of 0.2386 sec while the maximum possible propagation time delay between any two footprints is that between L-band Navigation payload L1 beam and itself or L-band Navigation payload L5 beam and itself with value of 0.2832 sec.

References

Goyal, R.; R. Jain; M. Goyal; S. Fahmy; B. Vandalore and T. vonDeak (1999). Traffic Management in ATM Networks over Satellite Links. Technical Report, NASA Glenn Research Center; Cleveland, OH United States.
Ibiyemi, T. S., and Ajiboye, A. T. (2012a). Automatic Tracking of NigComSat-1R Satellite by Dish Network Mounted on Mobile Tele-Medicine Vehicles. International Journal of Engineering Research & Technology, 1(4): 1-4.
Ibiyemi, T. S., & Ajiboye, A. T. (2012b). On PID Controller Design for Mobile Node Network with Variable Delays. International Journal of Science and Advanced Technology, 2(4):176-180.
Khan, A.; D. Tilbury; and J. Moyne. (2008). Favorable effect of time delays on tracking performance of type-I control systems. IET Control Theory & Applications, 2(3): 210-218.
Kolawole, M. O. (2002). Satellite communication engineering. Marcel Dekker New York.
Kumar, V., & Kumar, R. (2013). Effect of Network-Induced Delay on Stability in Networked Control System. International Journal of Scientific Research, 2(4):18-21.
Nwajiobi, E. N. (2012). The Nigerian Communications Satellite (NIGCOMSAT-1R): Relevance and Impact on Information and Communications Technology (ICT) Development in Nigeria and Africa . Journal of Research in Pure and Applied Sciences,1(1): 28-36.
SATBEAMS. (2017). Footprints. Retrieved 16/04/2017,from http://www.satbeams.com/footprints
Vatanski, N.; J. P. Georges, C. Aubrun; E. Rondeau, and S-L. J. Jounela. (2006). Control compensation based on upper bound delay in networked control systems. arXiv preprint cs/0609151.

Downloads

Published

2019-06-05

Issue

Section

Articles