Assessment of Structural Strength of Commercial Sandcrete Blocks in Kano State
Abstract
This research was aimed at studying the strength properties of the commercial sandcrete blocks produced in Kano State. A total number of 250 block samples were randomly collected from five local government areas, fifty (50) from each of the local governments and cured for 3, 7, 14, 21 and 28 days. The blocks were subjected to various tests at wet and dry conditions as follow: wet compressive test, drying shrinkage, moisture movement and density all in accordance with established standards in the structural laboratory of Department of Civil Engineering, Ahmadu Bello University, Zaria, and the aggregates were subjected to sieve analysis and moisture content determination in the Geotechnical Laboratory of the department. The compressive strength was found to be between 0.25 N/mm2 and 0.92 N/mm2 which are far below the specified values (2.5 N/mm2 to 3.45N/mm2 respectively) in the Nigerian Industrial Standard (NIS 87, 2000). It is concluded that the commercially produced sandcrete blocks in Kano State are of lower standard than expected. It is recommended that workshop should be organised periodically to enlighten the producers of sandcrete blocks. The importance of adhering to standard specifications should be emphasised and strict penalties be meted out to erring producers by the Nigerian Industrial Standard Organisation.
Downloads
Published
Issue
Section
License
In accordance with the Copyright Act of 1976, which became effective January 1, 1978, the following statement signed by each author must accompany the manuscript submitted: "I, the undersigned author, transfer all copyright ownership of the manuscript referenced above to the Nigerian Journal of Technological Development, in the event the work is published. I warrant that the article is original, does not infringe upon any copyright or other proprietary right of any third party, is not under consideration by another journal, and has not been published previously. I have reviewed and approve the submitted version of the manuscript and agree to its publication in the Nigerian Journal of Technological Development." A copyright transfer form should be downloaded from the NJTD Website ( http://njtd.com.ng/index.php/njtd). Author(s) will be consulted, whenever possible, regarding republication of material. All authors must have access to the data presented and the authors and sponsor (if applicable) must agree to share original data with the editor if requested.
