Capacities and Irreversibility of the Vapour Compression Refrigeration System’s Components using Aluminium oxide (Al2O3) based Nanolubricants
Keywords:
aluminium oxide, efficiency, capacities, nanorefrigerant, VCRSAbstract
Vapour compression refrigeration systems (VCRS) are used for cooling and preservation. Hydrochlorofluorocarbons (HCFC) and chlorofluorocarbon (CFC) commonly used as refrigerants have been phased out due to their negative impact on human and the environment. R134a and R600a refrigerants have been proposed as replacement to HCFC and CFC refrigerants, but they possess low thermal properties. In this study, the thermal property of R134a and R600a were enhanced by dispersing aluminium oxide (Al2O3) nanoparticles of 10 nm, 20 – 30 nm, and 80nm size, hence, enhancing the performance of the VCRS. Nanolubricant were prepared using the two-step method with varying nanoparticle volume concentrations of 1% to 20%. The capacities and irreversibility of each component of the VCRS were analysed using Al2O3 nanolubricant as the compressor oil. The heat transfer characteristics and exergy efficiency of the vapour compression system improved with the addition of nanoparticles into the system. The exergy destruction caused by friction in the compressor was significantly reduced with nanolubricant leading to lower power consumption by the system. The lower nanoparticle size (10 nm) was more efficient than the larger sizes. The heat transfer characteristics and exergy efficiency of R600a and its nanorefrigerants were better than that of R134a and its nanorefrigerants.
References
Abdulftah, A.K.S. and M. Tariq (2019). Experimental Analysis of Vapor Compression Refrigeration System Using Nano-Refrigerant. World Journal of Engineering Research and Technology, 5 (3): 325-339.
Ajayi, O.O.; T.I. Okolo; Y.S. Enesi; F.T. Owoeye; E.T. Akinlabu; S.T. Akinlabi and S.A. Afolalu. (2019). Performance and Energy Consumption Analyses of R290/Bio-Based Nanolubricant as a Replacement for R22 Refrigerant in Air-Conditioning System. Energy Technology, The Minerals, Metals and Materials Series, Springer, 103 – 112.
Ajayi, O.O.; D.E. Ukasoanya; F.T. Owoeye; E.Y. Salawu; I.O. Ohijeagbon; F. A. Oyawale, and M.C. Agarana. (2018). Experimental Investigation into the Effects of Al-Composite Nanolubricants on the Energy and Exergy Performance of Vapour Compression Refrigerator Compressor. Proceedings of the World Congress on Engineering 2018 Vol II. London, U.K.
Ali, A.R.I. and B. Salam. (2020). A review on nanofluid: preparation, stability, thermophysical properties, heat transfer characteristics and application. SN Appl. Sci. 2, 1636. https://doi.org/10.1007/s42452-020-03427-1
Baskaran A.; N. Manikandan; JuleLeta Tesfaye, N. Nagaprasad; R. Krishnaraj. (2022). Investigation on the Performance of Domestic Refrigerator with Zirconium Oxide-R134a Nanorefrigerant. Journal of Nanomaterials, vol. 2022, Article ID 3668458, 11 pages, 2022. https://doi.org/10.1155/2022/3668458
Faizan, A., and D. Han. (2016). Thermophysical Property and Heat Transfer Analysis of R245fa/Al2O3 Nanorefrigerant. The International Journal of Engineering and Science (IJES), 5 (4): 45 – 53.
Katoch A.; F.A. Razak; A. Suresh; B. BS and E. Gundabattini. (2022). Performance Analysis of Nano-Refrigerants used in the Vapor Compression Refrigeration System using MATLAB-Simulink. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 236 (12):6948-6966. doi:10.1177/09544062211069886
Karthick M.; K. Senthilkumar and K. Varatharajan (2020). Performance Investigation and Exergy Analysis of VCRS Operated Using R600a Refrigerant and Nanoadditive Compressor Oil. Thermal science, 24 (5): 2977 – 2989.
Kumar, R.; D.K. Singh and S. Chander. (2022). A critical review on the effect of nanorefrigerant and nanolubricant on the performance of heat transfer cycles. Heat Mass Transfer 58: 1507–1531. https://doi.org/10.1007/s00231-022-03194-2
Kundan, L. and K. Singh. (2020). Improved Performance of a Nanorefrigerant-Based Vapor Compression Refrigeration System: A New Alternative. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy. https://doi.org/10.1177/0957650920904553
Kushwaha, P.K.; P. Shrivastava and A. K. Shrivastava. (2016). Experimental Study of Nanorefrigerant (R134a+Al2O3) Based on Vapor Compression Refrigeration System. International Journal of Mechanical and Production Engineering, 4 (3): 90-95.
Mahdi, Q.S.; M.A. Theeb and H. Saed. (2017). Enhancement on the Performance of Refrigeration System using the Nano-Refrigerant. Journal of Energy and Power Engineering, 11: 237-243. DOI: 10.17265/1934-8975/2017.04.004
Manasa E.; M.V.S. Murali Krishna and C. I. Priyadarsini. (2021). Enhancement of Thermophysical Properties of Nano Refrigerant, International Journal of Mechanical Engineering and Technology (IJMET), 12 (7): 10-16.
Mishra R. S. (2015) Energy-Exergy Performance Comparison of Vapour Compression Refrigeration Systems using Three Nano Materials Mixed in R718 in the Secondary Fluid and Eco-friendly Refrigerants in the Primary Circuit and Direct Mixing of Nano Materials in the Refrigerants. International Journal of Advance Research and Innovation,3 (3): 471-477.
Mohamed, H.E.; U. Camdali and M. Aktas. (2022). Viscosity and Density of Polyolester Oils Based on CuO/CeO2 Mixture Nanoparticles. Acta Scientific Computer Sciences 4.9: 30-39.
Ogbonnaya, M.; O.O. Ajayi and M.A. Waheed (2023). Influence of Refrigerant Type, Nanoparticle’s Concentration and Size on the Performance and Exergy Efficiency of the Vapour Compression Refrigeration System Using Al2O3 based Nanolubricant. Journal of Nanofluid. Accepted for Publication.
Ogbonnaya, M.; O.O. Ajayi; M.A. Waheed and E.Y. Salawu. (2022). Thermophysical Properties and Heat Transfer Characteristics of Nanorefrigerants: Some Existing Results and Areas for Further Research. Key Engineering Materials. 917: 207-227. doi:10.4028/p-j63e4z.
Ogbonnaya, M.; O.O. Ajayi and M.A. Waheed (2020). Effect of Nanoparticles Size and Concentration on the Thermophysical Properties of Al2O3 Nanolubricant for use in Vapour Compression Refrigeration System. Solid State Technology, 63 (6), 7728 – 7739.
Patil, M.S., Kim, S.C., Seo, J., & Lee, M. (2006). Review of the Thermophysical Properties and Performance Characteristics of a Refrigeration System using Refrigerant-Based Nanofluids. Energies, 8: 1 – 16. Doi 10,3390/en9010022
Sanukrishna, S. S.; N. Ajmal and M. Jose-Prakash. (2018). Thermophysical and Heat transfer Characteristics of R134a-TiO2 Nanorefrigerant: A Numerical Investigation. 28th International Conference on Low Temperature Physics (LT28). IOP Conf. Series: Journal of Physics: Conf. Series 969 (2018) 012015.
Sanukrishna, S.S.; A.S. Vishnu and M. Jose-Prakash, (2017). Nanorefrigerants for Energy Efficient Refrigeration System. Journal of Mechanical Science and Technology, 31: 3993 – 4001.
Sharma, A.K., A.K. Tiwari and A.R. Dixit. (2016). Rheological Behaviour of Nanofluids: A Review. Renewable Sustainable Energy Review, 53: 779–791.
Sharma, T. and K.L. Rana. (2015). An Experimental investigation of nanorefrigerant based refrigeration system. International Journal of Electronics, Electrical and Computational System, 4, 317 – 322.
Singh, B. K. and S. Ansari. (2017). Experimental study of nanorefrigerant (HC+Cu) based refrigeration system. International Journal of Scientific Research in Science, Engineering and Technology, 3 (8): 1076-1076.
UNEP. (1997). Montreal Protocol on Substances that Deplete the Ozone Layer. Final Act. New York: United Nation Environment Program.
Yang, D.; B. Sun; H. Li and X. Fan, (2015). Experimental Study on the Heat Transfer and Flow Characteristics of Nanorefrigerants inside a Corrugated Tube. International Journal of Refrigeration, 56: 213–223.
Yilmaz, A.C. (2020). Performance evaluation of a refrigeration system using nanolubricant. Applied Nanoscience, 10: 1667–1678. https://doi.org/10.1007/s13204-020-01258-5
Downloads
Published
Issue
Section
License
Copyright (c) 2023 Nigerian Journal of Technological Development
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
In accordance with the Copyright Act of 1976, which became effective January 1, 1978, the following statement signed by each author must accompany the manuscript submitted: "I, the undersigned author, transfer all copyright ownership of the manuscript referenced above to the Nigerian Journal of Technological Development, in the event the work is published. I warrant that the article is original, does not infringe upon any copyright or other proprietary right of any third party, is not under consideration by another journal, and has not been published previously. I have reviewed and approve the submitted version of the manuscript and agree to its publication in the Nigerian Journal of Technological Development." A copyright transfer form should be downloaded from the NJTD Website ( http://njtd.com.ng/index.php/njtd). Author(s) will be consulted, whenever possible, regarding republication of material. All authors must have access to the data presented and the authors and sponsor (if applicable) must agree to share original data with the editor if requested.
