Modelling Safety Factors of Slope Stability for Open-Pit Mining of Nigerian Tar-Sand Deposits
Keywords:
Dahomey Basin, Tar-sand, Bench face angle, slope stability, Open-pit mine and factor of safetyAbstract
Slope failure might lead to loss of lives and valuable equipment which would increase overall operational cost of running a mine. The need to have stable slopes in open-pit mining of Nigerian tar sand deposits of Dahomey Basin, Southwestern Nigeria is emphasized in this study. At Loda village, Southwestern Nigeria, samples of the laterite soil and alluvial sand which overlie the tar sand occurrence were subjected to geotechnical tests. Computer simulation of bench face angles was carried out using SLOPE/W Software to determine the bench face angle(s) with the least susceptibility to failure.
Unit weight (ö), cohesion (c) and angle of internal friction (0) values for the laterite soil were 25 kN/m, 45 kPa and 41 respectively for laterite. The corresponding values for the laterite, soil were 18 kN/m3, 0kPa and 34°. These values were used to run the software programme to simulate different bench face angles that could be cut into the two lithologic units. Factors of safety values between 3.58 and 1.73 were obtained for bench face angles between 10° and 30° which are least susceptible to failure even when inundation is considered. This research results have enabled us to recommend the use of bench slope angles ranging from 10° and 30° coupled with adequate drainage conditions which should guaranty optimum output.
Downloads
Published
Issue
Section
License
In accordance with the Copyright Act of 1976, which became effective January 1, 1978, the following statement signed by each author must accompany the manuscript submitted: "I, the undersigned author, transfer all copyright ownership of the manuscript referenced above to the Nigerian Journal of Technological Development, in the event the work is published. I warrant that the article is original, does not infringe upon any copyright or other proprietary right of any third party, is not under consideration by another journal, and has not been published previously. I have reviewed and approve the submitted version of the manuscript and agree to its publication in the Nigerian Journal of Technological Development." A copyright transfer form should be downloaded from the NJTD Website ( http://njtd.com.ng/index.php/njtd). Author(s) will be consulted, whenever possible, regarding republication of material. All authors must have access to the data presented and the authors and sponsor (if applicable) must agree to share original data with the editor if requested.
